The Effect of Adding Prim ary Epoxy on the Corrosion Rate of Low Carbon Steel in 5.25% Calcium Hypochlorite Solution
DOI:
https://doi.org/10.21063/jtm.2022.v12.i2.120-123Keywords:
Corrosion, corrosion rate, epoxy primer, low carbon steel, calcium hypochloriteAbstract
The corrosion process occurs in almost all materials, especially metals, slowly but surely, which can cause a material to have a limited service life. Corrosion cannot be prevented but the rate can be reduced. One of t he methods to inhibit the effective corrosion rate is by giving epoxy primer treatment. This study aims to examine the effect of adding epoxy primer on the corrosion rate of low carbon steel immersed in a 5.25% Calcium hypochlorite solution. This research was conducted using 27 specimens in 9 vessels, each vessel contained 3 specimens immersed in low carbon steel without treatment, oil paint and epoxy primer. Volume of 1 liter of solution for 1 vessel. The results of this study indicate that the epoxy primer is able to inhibit the corrosion rate well. The reduction in weight of low carbon steel treated with oil paint is much greater than that of untreated low carbon steel using epoxy primer. The lowest corrosion rate was given by applying epoxy primer in 30 days of immersion with an average value of 0.001001695 mpy and the highest corrosion rate without treatment in 15 days of immersion with an average value of 0.005008473 mpy.
References
Bayuseno, A. P. 2009. Analisa Laju Korosi pada Baja untuk Material Kapal dengan dan Tanpa Perlindungan Cat.ROTASI,11(3):32-37.
Abdallah, M. 2002. Rhodanine Azosulpha Drugs as Corrosion Inhibitors for Corrosion of 304 Stainless Steel in Hydrochloric Acid Solution.Corrosion Science,44(4):717-728.
Muhammad, MM.,Agung,P., Hosta,A. 2015. Pengaruh Komposisi Pelarut dan Ketebalan Cat Epoksi Terhadap Daya Lekat dan Tingkat Pelepuhan (Blistering) pada Lingkungan NaCl yang Diaplikasikan pada Baja Karbon.Prosiding Seminar Nasional Material dan Metalurgi:144-149.
Nugroho, F. 2015. Penggunaan Inhibitor untukMeningkatkan Ketahanan Korosi padaBaja Karbon Rendah.Jurnal Angkasa,7(1):151-158.
PT. TOYOTA –ASTRA MOTOR. 1999. Manual Training Pengecatan Metode Persiapan Permukaan II.Vol. 1.TPM201EI-TPM204EI. Jakarta: PT. toyota-astra motor.
Putra, Ismet Eka . 2007. Pengaruh Laju Korosi Paduan Al dan Paduan Cu dalam Larutan NaCl 3,56% Terhadap Kekuatan Tarik dan Patahnya: Sumatera Barat, Padang.
Setyarini, P. H., dan Sulistyo, E.2011. Optimasi Proses Sand Blasting terhadapLaju Korosi Hasil Pengecatan Baja Aisi 430.Rekayasa Mesin,2(2):106-109.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Ismet Eka Putra, Haleri Echo Yeyen Hidayat
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.