Surface Roughness Analysis in Turning of AISI 1045 Steel with Anova and Scheffe Test
DOI:
https://doi.org/10.21063/jtm.2018.v8.i2.67-72Kata Kunci:
Turning, Surface Roughness, AISI 1045, Anova, ScheffeAbstrak
Turning process is a very important machining process in the manufacturing industry. The quality characteristics of a turning machining product can be seen from the level of surface roughness carried out in the turning process. The purpose of this study was to determine the effect of spindle speed, feeding and the main cutting angle on surface roughness. Surface roughness measurement using a surftest SJ-301. The material used in this study is AISI 1045 steel. While analysis of variance (ANOVA) is used to process data. The results showed that the lowest surface roughness can be achieved at spindle speed of 765 rpm, feeding of 0.15 mm / rev and main cutting angle of 85. Data analysis explained that the spindle speed, feeding and main cutting angle had a significant effect on surface roughness. Increased spindle speed, feeding and main cutting angle will reduce surface roughness. The scheffe test results also show contrasting results between the variables studied.
Referensi
P. Jayaraman and L. Mahesh kumar, “Multi-response optimization of machining parameters of turning AA6063 T6 aluminium alloy using grey relational analysis in Taguchi method,” Procedia Eng., vol. 97, pp. 197–204, 2014.
M. V. Ramana, “Optimization of Material Removal Rate in Turning of AISI 321 Stainless Steel Using Taguchi Methodology,” Mater. Today Proc., vol. 5, no. 2, pp. 4965–4970, 2018.
A. Gupta, H. Singh, and A. Aggarwal, Taguchi-fuzzy multi output optimization (MOO) in high speed CNC turning of AISI P-20 tool steel, vol. 38, no. 6. Elsevier Ltd, 2011.
S. Kalpakjian and S. R. Schmid, “Manufacturing engineering and technology,” Manuf. Eng. Technol., 2014.
P. Herdaagus, P. J. Widodo, and M. Nizam, “PENGARUH PARAMETER PERMESINAN BUBUT TERHADAP MUNCULNYA BUILT UP EDGE (BUE) DALAM PROSES PEMBUBUTAN ALUMINIUM,” MEKANIKA, 2011.
G. A. Ibrahim, “Identifikasi Nilai Kekasaran Permukaan pada Pemesinan Paduan Magnesium,” J. Mech., 2014.
P. G. Benardos and G. C. Vosniakos, “Predicting surface roughness in machining: A review,” Int. J. Mach. Tools Manuf., vol. 43, no. 8, pp. 833–844, 2003.
Paridawati, “Pengaruh kecepatan dan sudut potong terhadap kekasaran benda kerja pada mesin bubut,” J. Ilm. Tek. Mesin, vol. 3, no. 1, pp. 53–67, 2015.
A. Mufarrih, “Pengaruh Parameter Proses Gurdi Terhadap Kekasaran Permukaan Pada Material KFRP Komposit,” Semin. Nas. Inov. Teknol., pp. 403–410, 2017.
Unduhan
Diterbitkan
Terbitan
Bagian
Lisensi
Hak Cipta (c) 2018 A.Mufarrih
Artikel ini berlisensiCreative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
