Vol. 8 No. 2 (2018): Jurnal Teknik Mesin Vol.8 No.2 October 2018

Article

• Effect of Point Angle on Delamination in Drilling of KFRP Composite

  Mohammad Muslimin Ilham, Am. Mufarrih

  51-55

  • PDF (Bahasa Indonesia)

• Analysis of Current, Filler Metal, and Groove on Tensile Strength and Hardness of Dissimilar Welding Using Gas Tungsten Arc Welding (GTAW)

  Eriek Wahyu Restu Widodo, Vuri Ayu Setyowati, Suheni Suheni

  56-60

  • PDF (Bahasa Indonesia)

• The Potential of Brantas River Iron Sand as A Source of Silica and Calsite Materials

  Ah. Sulhan Fauzi , Yasinta Sindy Pramesti

  61-66

  • PDF (Bahasa Indonesia)

• Surface Roughness Analysis in Turning of AISI 1045 Steel with Anova and Scheffe Test

  Am. Mufarrih, Hesti Istiqlaliyah, Mohammad Zaenal Fanani

  67-72

  • PDF (Bahasa Indonesia)

• Flying Time Of Quadcopter Based On Green Composites Material

  Mastariyanto Perdana, Nurzal, Syahrul Firdaus, Rozi Saferi

  73-77

  • PDF (Bahasa Indonesia)

• Basic Dual-Arm Manipulator Kinematics Using Forward Kinematics Method and Aided by Autodesk Inventor

  Asmara Yanto

  78-87

  • PDF (Bahasa Indonesia)

• Static Analysis of Structural Structure of Vertical Wind Tunnel (VWT) Design By Catia V5R21

  Muhamad Jalu Purnomo

  88-92

  • PDF (Bahasa Indonesia)

• Effect Of Special Tool Completeness During Regular Service At Two Official Honda Workshops (HCM & CPM) Padang On Customer Satisfaction

  Dian Wahyu

  93-100

  • PDF (Bahasa Indonesia)